The start button does not work. The buttons on the upper panel work fine. What needs to be replaced.
The most likely cause for the start button not working would either be a faulty keypad 154554401 or a bad door latch assembly. You will want to check the switches on the latch assembly to make sure that they are good and if they check ok then the keypad would be the issue.
The PF code is flashing on the display. The Hi Temp Wash button and the Sanitize button are also flashing with the display. The dishwasher will work until this occurs. After this has occurred I have tried to restart the cycle. This error sequence immediately reoccurs. If I wait awhile the cycle will restart but for only a short period of time before the cycle stops and the same error flashes. Any help is appreciated.
Answer Hello Jeremy,
PF is the code for power failure. This basically means that the control board has lost its' connection to the power supply. You should first turn the breaker off to the unit and verify the power is off. Now remove the kick panel and open the small galvanized box on the right of the unit. This is the power connection junction box. Look for any of the wire nuts blackened, dis-colored, or melted. If you find one like this, you have located the issue. If not, check the door switches in the door panel next.