To replace Electronic control assy does it pull out of the front of the door or do you have to remove the inner door panel?
Answer Tim, It's not a difficult repair, but you do have to be careful not to scratch or damage the door panel. Here's some help : Precision Set Control Assembly Removal The Precision Set control assembly is mounted inside the front of the door assembly and is secured in position
with retaining latches. To remove the Precision Set control assembly: 1. Disconnect power to freezer. 2. Using a small flat bladed screwdriver or equivalent tool carefully pry under the bezel until the retaining latches release from the door assembly. Pull control assembly straight out to avoid damaging the electrical connection wire prongs. To install the Precision Set Control Assembly : 1. Push control in gently with the palm of your hand. You may need to slightly adjust the bezel position up or down to align connector pins. 2. Gently push control flush to the door with palm of hand. "