The drum wont spin in any cycle. It fills and empties. The belt is good and the drum turns freely. The control clicks like it did when the drum cycled directions. Is the control board a large percentage of the causes?
Answer Hi Flstskeith. Remove the drum belt and see if the motor itself will normally run. If so then the drum assy. is the issue. Access the pressure switch. Unhook the hose and blow back ward into the tub. Did you remove any obstruction? If so you can use washer magic monthly to insure proper performance. Take a same size hose and blow into the pressure switch to reset the contacts. Start The washer and blow into the switch, does it start to agitate now? You can also bypass the switch if your careful. If so you will need pressure switch part # 134433701. Your timer may not be sending 120 vac to the wash circuit. Part # 131717100. Use the wiring diagram supplied inside the cabinet to help assist. Thank You.
Kenmore front load coin operated washer will not wash or spin. Replaced door lock mechanism,door strike and timer. Machine starts,pumps water and drains but still won't wash or spin.
Answer Hi Bob. Is the tub free and motor free spinning separate of the belt? Is there anything stopping the drum? Can you run the motor without the belt? Are there any fault codes? There is a tech. sheet in the cabinet folded in a packet. Use this to put unit in a field service test. The motor specs are there to check the board, connections and the windings. Motor part # 131276200. Thank You.
Okay the timer seems to work fine but when the washer goes into spin mode. The washer does not speed up like it use too when I first brought the machine and because of that the clothes out real wet. Like I said the timer complets the whole cycle. Thanks
Answer Hello Zaid. You will need to check and see if the door lock assembly 131763202 is bad and will need to be replaced. If so, it will cause the problem you are having. The wax motor on the lock assembly, if bad, will cause a low spin speed. The door will still lock, but does not send the signal to the control board. Hope this helps.