Is there a handle only for model FFMU152CLBA Microwave oven, How does the inside door remove to replace handle?
Answer Hello Bruce. The model number you provided is not working. We will need your model number to help you with this. Please call 1-877-477-7278 or post your model number with a new question on the parts page. http://www.appliancepartspros.com/modelnumber_locator.aspx
I Have a Frigidaire Microware CFMV157GCA. The glass in the front of the door completely shattered. Can I replace the door and do you have instructions on how to do that?
Answer Hello Ryan,
The complete door can be ordered 5304477387 and the instructions are as follows: 1. Disconnect the power supply cord.
2. Open the door and block it open. 3. To discharge the high voltage capacitor, wait for 60 seconds. 4. Remove the three (3) screws holding the hood exhaust louver to the oven cavity front face plate. 5. Remove the hood exhaust louver from the oven cavity by pushing the right and left tabs of the hood exhaust louver. 6. Insert a putty knife (thickness of about 0.5mm) into the gap A between the door stopper and the choke cover to free engaging parts. 7. Lift up the door stopper. 8. Now, the door stopper is free from the door assembly. 9. Lift up the door assembly to release the upper and lower door hinge pins from the upper and lower oven hinges. 10. Now, the door assembly is free. To re-install: 1. On re-installing door, insert the lower oven hinge to lower door hinge pin. 2. Insert the upper oven hinge to the upper door hinge
pin. 3. Shut the door (close the contacts of interlock switches). 4. Make sure upper and lower oven hinges are inserted into the upper an lower door hinge pins. 5. Make sure the door is parallel with oven face lines (left and upper side lines) and door latch heads pass through
latch holes correctly. 6. Re-install the door stopper to the door assembly. 7. Re-install the hood exhaust louver to the oven cavity front
face plate with the three (3) screws. Note: After any service to the door; (A) Make sure that door sensing switch and primary interlock switch are operating properly. (B) An approved microwave survey meter should be used to assure compliance with proper microwave
radiation emission limitation standards. After any servicing, make sure of the following: 1. Door latch heads smoothly catch latch hook through latch holes and that latch head goes through center of latch hole. 2. Deviation of door alignment from horizontal line of cavity
face plate is to be less than 1.0mm. 3. Door is positioned with its face pressed toward cavity face plate. 4. Re-install outer case and check for microwave leakage around door with an approved microwave survey meter. Note: The door on a microwave oven is designed to
act as an electronic seal preventing the leakage of microwave energy from oven cavity during cook cycle. This function does not require that
door be air-tight, moisture (condensation)-tight or light-tight. Therefore, occasional appearance of moisture, light or sensing of gentle warm air movement around oven door is not abnormal and do not of themselves indicate a leakage of microwave energy from oven cavity.