This is a Frigidaire Professional Series serial #7G60706871The hinges on the door must have broken as the door sags and needs to be aligned to close properly. The microwave works great but the doors is an issue. How can I repair this I have no visible screws on the left side of the microwave and when the panel for the door is removed i don't see anything I could reach to fix.
Answer Hello Luis,
DOOR ASSEMBLY REMOVAL 1.Disconnect the power supply cord and remove the oven from wall and remove outer case. 2.Open the door and block it open. 3.Discharge high voltage capacitor. 4.Remove the hood exhaust louver from the oven cavity by pushing the right and left tabs of the hood exhaust louver. 5.Insert a putty knife (thickness of about 0.5mm) into the gap A between the door stopper and the choke cover to free engaging parts. 6. Lift up the door stopper. 7. Now, the door stopper is free from the door assembly. 8. Lift up the door assembly to release the upper and lower door hinge pins from the upper and lower oven hinges. 9. Now, the door assembly is free. DOOR ASSEMBLY RE-INSTALL 1.On re-installing door, insert the lower oven hinge to lower door hinge pin. 2. Insert the upper oven hinge to the upper door hinge pin. 3.Shut the door (close the contacts of interlock switches). 4. Make sure upper and lower oven hinges are inserted into
the upper an lower door hinge pins. 5.Make sure the door is parallel with oven face lines (left and upper side lines) and door latch heads pass through latch holes correctly. 6.Re-install the door stopper to the door assembly. 7. Re-install the hood exhaust louver to the oven cavity front face plate. Note: After any service to the door; (A) Make sure that door sensing switch and secondary interlock switch are operating properly. (B) An approved microwave survey meter should be used to assure compliance with proper microwave radiation emission limitation standards.
Someone with the exact same product asked this question, but I did not see the response. Our microwave door has loose hinges on the bottom left. It hangs down when it is opened. Does this mean that the whole door needs to be replaced? It seems that the problem is more from within the panel, where a screw might have come loose that helped to keep the door upright. What do you think?
If the door hinge itself is sagging then you would want to remove the cabinet of the unit and see if there is a screw that holds the hinge. If there is then it may just need to be tightened. If there are no screws and it is welded and the weld has broken then the part would not be able to be fixed. If the door is cracked and causing the door to sag then you would need to replace the door.