Drain Pump Assembly

Jack for Model Number FDB2310LCC@

Answer Hello Jack. Disassemble the dishwasher and see if any debris is clogging the pump or the drain hose. If all is clear, you will need to change the pump. Hope this helps. 

2 people found this answer helpful.

Tom for Model Number fdb1050rem2

Answer Tom, The easiest way to replace the pump is to pull unit out and turn on its back to access the pump. It will give you easier access. 

Anthony for Model Number FDB1100RHCO

Answer Anthony, Normally the drain will carry 10 foot but since it runs down then back up to a trap then back to down it cannot handle this. It is possible that the drain may be clogged also which would cause it to be even slower. The drain should run straight across up to a trap then back to disposal. 

Steve for Model Number fghd2433kf1

Answer Hello Steve, Remove the kick panel and check the wires with a test meter. If there is no voltage, (120Vac), when the unit is supposed to drain, check for voltage at the control board on the same wires. If there is still no voltage there, replace the control 154815601. If there is voltage at the drain pump when it should be draining, replace the drain pump 154736201. 

Brad for Model Number Frigidair ultra quiet 111

Answer Hello Brad. If the pump and hose are clear, and the unit does not drain, replace the pump on the unit. 

Jerry for Model Number GSD5310Do2aa

Answer Hello Jerry, You will want to make sure that your pump has not got debris in it causing slow drain. Also check your drain hoses. This is the most common problem of having water standing in the unit. Also double check to make sure that the drain pump impeller is not bad or damaged.