Just had an incident. Dishwasher is not draining. I have read the posts only question. What position of rotation should I have the switch while testing for power to the pump?
Mw for Model Number FDB710CS0
Answer Hi Mw. Just before OFF- the pump will go into a 2 minute drain. Open the door and advance the timer clockwise to one notch before off. Have you're meter lead prongs already set on the pump connector (with the pump disconnected). If you ohm out the drain pump to 28 ohms and each lead to pump chassis to see if the windings are shorted. If they are shorted then replace the pump part # [AP43618633]. If the impeller is spinning loose on the shaft - replace it also. Disconnect the drain hose under the sink and see if the restriction is there at the sink end. Thank You.
Have replaced pump on dishwasher part#ap4318633 dishwasher still does not empty. Have looked for obstruction in hose. Only has a little trickle of water that comes out when unit tries to empty.
Jake for Model Number FDP635RFR3
Answer Hello Jake. Based on the model number you provided, you have installed the wrong kit, and will need to order 5304475805. It comes with a new drain hose, which based on the information you provided, sounds like what you will need for the unit. Hope this helps.