Replacing upright frezzer foor casket John B. • Windsor Locks, CT • October 08, 2014 My Repair & Advice Bought a new casket which was very expensive Like $155 expensive. This frezzer is 1991 so that makes it 23 yrs old. I spent several hours on this Project and had to give up.i was not able to Get the door to seal on all 4 sides .ittied to Adjust the hinges and this did not help. So I gave up and called in a appliance Person. He said the door was warped And proceeded to place his foot on the Bottom of the door and then grabed The top of the door and then holding The bottom in with his foot pulled on the Top of the door several times to get a Near perfect fit of the casket. He then heated The casket with a Hair dryer and then handed me a bill For $100. So $256 later I had a new Working casket . Was this review helpful to you?