How do you safely remove the housing dispenser? I have the four lower and the two upper screws removed and it won't pop off and I can't get the module cover (AP2114469) in front of it removed either.
Answer Hello Woods! To gain access to the control you will need to pull the drip tray out first. With the drip tray removed, remove the 3 screws at the bottom. Lift up on the front panel, there are tabs on the top of the panel that slide into holes in the door panel of the front panel. Swing the panel out to the side, being careful not to pull the wires out of the disconnect plug or the board itself. Hope this helps.