Won't spin dry and bruning smell.
Jarred for Model Number FWX833AS1
Answer Hello Jarred. Try turning the pulley by hand and see if the transmission is locked up. If so, you may need to replace the transmission 134735700 on the unit. Also, check and make sure nothing is between the tubs, and the tub bearing is good on the unit as well. Hope this helps.
How do you replace tension idler pulley ps418897?
Rob for Model Number mwx233rew1
Answer Hi Rob. You will need to 1st remove the belt tension off the pulley. Then there is a pin, spring and sleeve is on one end of the idler. You release the spring tension. Then remove the clip under the pin that is in the sleeve. After this you can remove the pin and reassemble in reverse order. Good luck. Thank you.
Have loud noise when washer goes into the spin cycle, installed a new belt, noise is still there but not as bad. Could problem be the tension pulley????
Dominick C. for Model Number FLGB43RGS2
Answer Hello Dominick. You will need to check the rear bearing 5303281153 and the front drum seal 5303937182 to see if they are worn. If so, they will need to be replaced. Hope this helps.