Ignitor

Shelly for Model Number 11021102012

Answer Shelley, You will want to check your fill hose screens on the water valve to ensure that they are not clogged. Also check the pressure hose for being clogged and check the drain for clogs. 

Juan for Model Number fgr311fs0

Answer Hello Juan, You will want to check your venting on the unit to make sure that it is clear from blower all the way to the outside of home. 

Juan for Model Number FGR311FS0

Answer Hello Juan, You need to check your dryer venting for restrictions. Clean out any lint from the lint trap, duct and blower assembly. If you still have issues, refer to this helpful link about common dryer problems. Hope this helps! http://www.appliancepartspros.com/repair-help/dryer-repair-help.html#gas 

Bob for Model Number Frigidaire Affinity AGQ7000ES1

Answer Hello Bob, You would want to do a continuity check on the thermostat and thermal fuse to check to make sure that they are good. If there is not continuity then they are bad. You would check continuity by taking off the leads on the part and checking across the terminals to see if you get a reading. If you do not get a reading then it is open. You would have to do an amp draw on the ignitor and should read 3.2 to 3.6 amps and if not then the ignitor is bad. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html 

Niko for Model Number AGQ6700FS0

Answer Hello Niko. Check for a stuck button on the control panel. If none is found, you will need to order and replace the control board 134557201. 

Nick for Model Number lgq1442eso

Answer Nick, as long as the igniter cycles off in a few seconds, and you're sure you have gas suppllied, then the most likely issue is a weak or "open" gas valve coil 5303931775 set. Thanks and Good Luck