It says the motor pulley is not seperate. Is'nt the pulley part of the motor shaft. In the picture it shows (gold) attached to shaft.
Brian for Model Number flsg72gcs9
Answer Hello Brian. The pulley comes with the motor. The manufacturer no longer sells it seperately. You are correct the pulley is the gold part attached to the shaft. Hope this helps.
1 person found this answer helpful.
my motor burn out and I replaced it and the same thing happened again. before I put the second motor in the gas line was not connected. When I tested the machine t work fine, but when i connect the gas line it work for a few second then the motor went bad again.. I checked for proper for voltage and found the correct 120 voltage. Could another component be the reason why the motor went bad the first and second time?, thanks.
Ps there is no model # on this machine or it missing.
Phillip for Model Number frigidaire gas dryer moto
Answer Phillip, Based on your description, the first thing to due is check for voltage on you gas supply line. Using a multi meter set the meter to read voltage, place one meter probe on the gas supply shut off or pipe, and the other probe on the cold water supply pipe, there should be NO / 0 voltage reading. If there is no voltage, you'll need to check and see where the wiring harness or component has shorted to the cabinet or chassis ground. Especially the L1(power) and N (neutral) wires to the motor, it sounds like the power supply is "scrambled" and you're supplying more than 132 volts to the motor, causing the motor to fail.