What parts do I need to change this stove from propane back to natural gas? Do I need to change the anything inside the regulator, or just the top burners?
To convert the unit back to natural from LP you will need the top burner orifices. The Left rear is part number 316237901, right front 316237900, Left front 316237902, and right rear 316237903. The bake and broil orifices you will want to loosen the orifice 1 1/2 to 2 turns and open the air shutters. The regulator cap will need to be flipped from LP back to natural.
What parts do I need to convert this from propane to natural gas?
Answer Hello Dawn,
The oven burners, (bake and broil), do not have to be replaced but must be adjusted. To go back to natural gas, you will need to back the burner hood out 1 3/4 to two turns. To convert the surface, you will need to remove the nut from the top of the regulator and rotate the plastic pin 180°. Snap it back to the undersidfe of the nut and reinstall. Now the orifices will have to be changed out. The LP studs are packaged with the unit when new and if the installer did his job right, they should still be with the unit, normally in the base near the safety valve. If not, you will need to purchase these and watch closely to get them install in the proper positions.
What parts do I need to change this from propane back to natural gas? Do I need to change the anything inside the oven itself or just the top burners?
To convert back to natural gas from LP you will need the following: Qty 1 12K orifice 316237901 and qty 3 9.5K orifice 316237902. The oven orifices you would loosen 2 turns and close off the shutters. The regulator you will flip the cap from LP to NAT.