Panel

Joe for Model Number Frigidaire PLES389DCB

Answer Hello Joe, The RTD is the oven sensor. You will want to do a resistance check on the oven sensor. The sensor at room temperature should be 1090 ohms. If it does not read this then you would need to replace the sensor. If your oven sensor ohms out properly then check your wiring from the sensor to control. If this checks ok then you will want to replace the EOC 316272204. 

Ken M

Answer Hello Ken, In order to get the ribbon connectors into place there are clips on the either side of the control connectors that you push in and lift. Once they are lifted then you would push the ribbon cable in place and push down on the connector to lock into place. 

Alexander for Model Number ples389dcc

Answer Hello Alexander! The manufacturer only offers the control panel 318239700 as a fully assembled part with the membrane. Thanks! 

Nancy for Model Number PLES389DCC

Answer Hello Nancy, You're right in the assumption that you need the clock assembly 316272204. If it were one of the thermostats that usually give issues on these units, you would have had to reset or replaced the thermostat to ever see a clock display. 

Miguel T. for Model Number Part Number: AP3586271 Made by Frigidaire

Answer Hi Miguel. Remove power. Remove door. Remove knobs. Remove bottom screws from control panel. Remove the keypad. Remove switch screws. Lift panel out of console. Reassemble in reverse. Thank You.