uo code after attempt to run cycle. Run diagnostic code HS continues to flash.. Replaced vent with new still error code uo when trying to start cycle. diagnostic showing hs code also after new part
Answer Allen, Here's some information : " UO > Vent open > While in wash cycle, Main Control Board does not receive signal from vent assembly that vent plunger is closed. Plunger status is sensed with optical sensor in vent assembly. Check wiring between vent assembly and Main Control Board. If wiring correct, replace vent assembly. If error still exist, replace Main Control Board. hs > Hall sensor > The control has sensed an error with hall sensor in motor. Check wiring between motor and Main Control Board. If correct, replace motor. If error still exist, replace Main Control Board. You'll want to recheck the connections at the vent assembly, and check for loose or damaged insulation on the harness at the bottom of the door. Then you'll need to remove the filter screens etc. and check to make sure there are no debris or articles stuck in the impeller on the wash motor assembly.
Water in dishwasher does not pump out. I replaced the pump, but water still does not pump out. When I hit wash cycle and reset, a low hum comes from new pump. Thank You
You will want to check the sump to make sure that it is not clogged causing water to not get to the drain pump. Also check for clogged or kinked drain line which would also cause this issue.
How do you install this part?
Answer Hello Michael. Pull out the dishwasher and lay it on it's back. Then remove the old sensor by twisting the sensor. The insert the new sensor 154762601 and lock it into place and attach the wires.