I get an ER code flashing sometimes at the end when the cycle is to begin drying and now it will not complete even a wash cycle without RE code popping up and stopping it. What part do I need to fix the problem?
We do not show a ER/RE error code associated with the unit but if this issue is occurring during the heating cycle then you will want to test the heating circuit to make sure that all components are good. Do a continuity test on the heater and thermostat and if there is no continuity then that part is bad. Also test to make sure that there is 120 vac going to the heating element from the control board. If there is then test at the heater to make sure that it is getting the 120 vac. If not then the wire harness is faulty. If there is no power going from the control board to the heating element then the control board is defective and would need to be replaced.