Dryer Timer

Brian R for Model Number FER641so

Answer Brian, Here is the wiring for your unit: Red goes to Terminal B, White goes to terminal C, Tan goes to terminal X, Black goes to Terminal R, Orange goes to terminal A. If you have a signal switch these wires will go to C and H. Resistor is between R and TM. 

Jake for Model Number fer641fso frigidaire dryer

Answer Hello Jake. You will need to test the element and see if it burnt out. Should read closed for continuity. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html 

Anthony Clem for Model Number FDERES1

Answer Hi Anthony, it is just a revision by the manufacturer (Frigidaire). It's very common for them to change parts from original production. Part# 131719100 is the correct part for your model. Thanks! 

Sanford for Model Number dryer model ger341cso

Answer Hello Sanford. H is black from buzzer, B is red, C is white, TM is timer motor, X is tan, Black to R from heater, and A is orange. 

Sanford for Model Number dryer model # ger341cso

Answer Hello Sanfor. Here is a link to the wiring diagram. http://www.appliancepartspros.com/partsearch/model.aspx?model_id=5155280&diagram_id=28913375 

Sanford R. for Model Number ger341cso

Answer Hello Sanford, Black to terminal B. Brown to terminal C. Tan to terminal X. Purple to R. Yellow to A. The end of cycle buzzer wires will go to terminals C and H. The 4.4KO resistor will go to terminals TM and R. The timer motor has two black wires which should be plugged onto terminals TM and C. I believe this is all of the wires. If not, you need to pull the tech sheet for your unit and verify by the information on your unit specifically. Since I'm not there to pull the tech sheet, I had to pull a generic wiring diagram from a generalized service manual.