My Frigidaire Laundry Center Fills and agitates, but does not pump or spin. The timer would make a slight buzzing/timer sound when it hits the spin cycle, but nothing else. I ordered a new timer and put it on and put to the spin cycle and it started to pump out water, but the water valve was opening at the same time. Upon further inspection I had received a timer that looked the same, but had a slightly different part#. But it was good because it showed that the pump was working. I sent the wrong timer back, received the new correct timer, installed it and it is doing the same thing the original timer was doing, no pump/no spin. Please help.
Answer Danny, The first check you need to make is the lid lock switch assembly 134101800. The neutral circuit to the timer is completed through the lock switch, if the switch does not complete the neutral circuit the washer wont drain and spin, but it will fill and wash.
When I turn timer knob the only cycle that works is the spin. No water comes in to fill washer.
Answer Hello Mike. Try the washer on both hot and cold settings and see if it brings in water on either cycle. If not, and there is no power coming to the water valve, you mat have a bad timer or pressure switch on the unit. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html
Hot water wont shut off even when unpluged.
Answer Hello Lloyd! It sounds like the hot water side of the inlet valve is defective and needs to be replaced. Your inlet valve is part number 134211400. Thanks!