Trunnion

Robin for Model Number 417.97812700

Answer Robin, There is a union under the basket that has 2 bolts that hold it together. Most likely this is broken and will need to be replaced for the tub being wobbly. For the belt not turning, look for the idler pulley to not be pushed up against the belt tightly and look for a worn belt. 

Jimmy B for Model Number GLET1041AS2

Answer Jimmy, These are "water related" parts, anything chipped, rusted, or rough, needs to be replaced, or you'll have an ongoing leak. The "brass" ring you're describing, should be the upper portion of the tub seal kit, and you'll be removing and replacing it with the seal kit 5303279394 . We'll send you some additional information that may be helpful. Thanks 

Yuji for Model Number 417.94862302 order number2640510

Answer Hi Yuji. All the bottom tub mount holes are threaded. The flat plate mount holes are large enough for the bolts to pass through them and bolt into the flat plate. Hold the trunnion up so the flat plate will be squarely bolted onto the side of the transmission shaft as you are tightening both bolts. Thank You. 

Joe for Model Number glet1041as1

Answer Hello Joe, Once you remove the two screws you can hit it with a rubber mallet to free it up and it just lifts out. There are bolts in the bottom of the tub under the trunnion to remove the outer tub. 

Joe for Model Number FWSB7800ds0

Answer Hello Joe. No, there is no torque specifications for the bolts. Make sure they are tight enough to support the tub to the trunnion 131545101. Hope this helps. 

Tim for Model Number frigidaire fws445rfs2

Answer Thye trunion part # 131545101, installs with your left hand pulling up on the bottom of the trunnion so the flat side of the transmission shaft,trunion, trunnion bar lines up so you can tighten the bolts to the flat bar against the transmission upper shaft. The inner tub will then bolt on top of the trunnion with the bolts in a non particular fashion. Thank you.