Our washer will not dispense warm or hot water most of the time. I installed a new triple water valve but that did not help. What else could it be?
You will want to test the ATC sensor that is located on the spout where the water comes into the tub. Test between the white and black wire for resistance. The resistance should be 47K ohms at room temperature of 77 degrees. If the sensor check bad then replace the sensor part number WH12X10410. If the sensor checks ok then the control board would be the issue part number WH12X10614.
How do I remove the back panel?
Answer Hi. Place a towel on the lid, in front of the control panel to protect the face of the controls. Remove power. Remove the 3 top 1/4# screws on the rear control panel. rotate the top of the control panel forward approx. 1" and slide to the right to unlock the 3-bottom locking tabs. Lift the panel up and off the cover panel and rotate down. Thank You.