Timer is not advancing. Runs constantly.
Answer Hello. Its sounds like the timer is defective and needs to be replaced. The correct timer for your model is part WE4M370
Dryer working fine in all settings. Heats up fine in all settings, but only advances to off in time setting. Will not advance in any other settings.
Answer Hi Rich. There is a moisture sensor control board part # WE04X10102 that senses the clothes moisture as they pass on the sensor bars under the front lower side of the inner drum lint screen. Look inside the unit and use a scotchbrite to lightly scuff up the bars to remove the fabric softener build up also to give it a fresh start. Thank You.
Dryer will run for 5-10 min then cutoff, will restart in a minute or so, replaced safety thermostat still having problem, what do you think is the problem?
Answer Hi Johnathon. The motor can overheat and the overload can temporarily open, part # is WE17X10010. The heating element can expand if the vent is clogged, temporarily shorting and opening a safety thermostat. Element part # is WE11M23. If the restring coil is needed then replace it with part # WE11M23. Thank you.