My automatic soap dispenser is full of water. What do I do?
Answer Hello John. It sounds like the seals are bad and you will need to replace the detergent kit WD35X10058 on the unit.
The smart dispense seems to be empty after only a few washes. It seems to be leaking out. I am not sure of what part to replace ?
Answer Hi Lynn...The amount varies depending on the hardness of your water and how dirty your dishes are. The soil sensor (turbidity sensor) determines how dirty your dishes are. You or your installer must program how hard or soft your water is (see your owners manual). There is a sensor that monitors the amount of detergent left in the reservoir and a low detergent light will come on when it gets low. Note that if you do not wish to use the smart dispenser system you can turn off the low detergent light. On most models pressing the added heat button five times within 3 seconds does this. Do the same to turn it back on. IF this doesn’t work or you do not have a button that says added heat, see your owner’s manual. IT is possible the dispenser nut is loose. Remove the top cover and see if you need to tighten it. Remove the inner door and look at this. If it is are leaking, replace the entire dispenser part # WD35X10058. Thank You.