Compressor Kit

Note: This question is for the older version of this part, but we thought you might still find it helpful

Jdizzle for Model Number bsy25gfmdww

Answer jDizzle, Yes, you should have 120 VAC at the compressor wires, not 12.5 VAC, apparently you do have a bad mother board WR55X10942 Thanks and Good Luck. 

1 person found this answer helpful.

Susie for Model Number gss25sgpess

Answer Hello Susie. Based on the information you provided, it sounds like you have a low freon issue or restriction. You will need an HVAC tech to repair the unit. 

Mike for Model Number GSS25WGMB

Answer Hello Mike. The part number is WR86X96. 

Liz for Model Number eterna series esl25xgre bs

Answer Hello Liz. Based on the information you provided, it sounds like the main control board WR55X10942 is bad and will need to be replaced on the unit. 

Syed S for Model Number gss25wgpd bb

Answer Hello Syed, The clear liquid you saw under the compressor was the water from when unit goes through a defrost cycle. The base where the compressor is located is also used as a drain pan and will collect water on a daily basis and evaporate from the heater of compressor and fan blowing across it. 

Diane for Model Number TFX26KPDAA

Answer Hello Diane. In order to complete the entire install of the compressor kit WR87X10226, the unit must be evacuated and charged by a HVAC technician.