I replaced the control board. Now when I plug the machine in, all of the LED's across the top just flash, and I can do nothing else. What do I need to do now?
Answer Hello John. You will need to check and make sure all the connections on the unit are good and tight. If so, try pluggin in the unit and selecting the cycles and see if the unit works properly then.
Is this a difficult part to be replaced by a novice? My washer seems stuck in the final spin cycle, is there anything I can check for?
Answer Hello Darrell. The control assembly WH12X10225 is not hard to replace. Check and make sure the drain pump is not clogged and the water is drain out of the machine properly. Hope this helps.