does my machine have a self diagnostic mode, if so how do I use it
Answer Curtis, Yes, your washer has a diagnostic and test mode. To enter or exit the test mode: Press power button to clear any current cycles. Note: The display must be blank to proceed. 2. Disconnect the power for 30 seconds. Reconnect power and within 30 seconds of reconnecting power: Press signal button. Press delay start button. Press signal button. Press delay start button. (The door will lock, then will display t01.) Note: A washer left in the test mode will exit the test mode and unlock the door after a period of 2 hours. t01 Model ID Verifies (or sets on new board) the proper model id. t02 Error Codes, Lists up to 10 control-detected problems, by pressing the Start/Pause button. You should be able to remove the lower access panel, and find the tech data information sheet attached to the left side of the cabinet interior near the motor control board, if it hasn't been removed and / or been lost.
Washer stopped working. Lights on control board botton flash 9 times, then stop for a second & flash again.
Answer Hello Jim,
You should pull the tech sheet and use the machines diagnostic mode to determine the failure. To recall an error code:
• Wake the machine by pressing any button
• Wait 5 seconds
• Press and hold the Start and Pause Cancel buttons simultaneously
• All LEDs will go blank and after a few seconds the control will signal the stored code using audible beeps and blinking LEDs. The control will repeatedly signal the code, as long as the Start and Pause Cancel buttons are pressed.