my washer intermittently will not go into a spin cycle. I replaced the control and it worked great on the first two loads but when I did a third load it went thru the rinse but would not enter into the spin cycle any suggestions?
Answer Hello Craig,
You will want to check the pressure switch hose for clogs or being kinked. Also check the drain pump to make sure that there is no clogging and that the vanes are in good condition. The drain being clogged would not allow unit to spin if there is water in the unit that is causing the pressure switch to stay closed.
How do I install control panel?
Answer Hi Juanita. Dis assembly – Control Panel. ?? To remove control panel, remove screws, then pry out on each side to release tabs,
then tilt forward & to the right. Control panel part # WH12X10271. Remove front knobs. Make sure that you have removed body static by grounding yourself first on bare cabinet metal.Do this a few times over and over. Try to touch only the outside corners so static does not inject into the board logic controls. Then mark all wire connections before removal so you insure proper installation. Use a cell phone picture if needed. The wiring diagram is supplied in the same area if needed for quick reference. Reinstall in reverse procedure. Thank You.