My built in gas oven only has one burner. If I push bake nothing happens but if I push broil it will light and work. Is this the oven control board giving me the problem?
Answer Hello Bobby,
Based on your model number you have an upper and lower burner on unit. The broil is the upper and the bake is below the oven bottom. Since the bake is not operating then you will want to do and amp draw on the ignitor WB2X9154. You should have between 3.0 and 3.6 amps and if you do not then you have a bad ignitor. You will also want to check your oven safety valve. Across the terminals bake to common you should have 216 ohms and between broil and common you should have 216 ohms. If this is not correct then you would need to replace the valve WB20X126.
My gas wall oven broiler burner will ignite but the bake burner will not. Can you suggest what to check? Thanks.
Answer Hi Anthony, it's most likely your bake burner ignitor WB2X9154. If not, you could also have a bad safety valve WB20X126. Hope this helps!
GE Oven blinks a code 7. Will part # ap3188925 repair this situation as conflicting support centers indicate.
Answer Hello John. Based on the code you recieved, it sounds like the control WB27T10267 is bad and will need to be replaced. Test the oven temperature sensor WB21X5301 and make sure it is reading around 1100 ohms at room temperature. If so, you will need to replace the control. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. Hope this helps.http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html