Washer works but does not spin out fast speed in the final rinse. It goes back and forth at a slow speed. At the very end of the cycle it should spin out at a high speed. could it be the timer or a control circuit.
Based on the information provided, the most likely cause of failure is the spin circuit not making. You will want to check the wiring between motor control and CCU. If wiring checks ok then you will want to replace the motor control board WH12X10154.
My washer will not spin. I cycle the washer on and it fills with water and drains the water but it will never spin. I've checked the door switch and the water level switch and they are operating properly.
Answer Maxwell, You most likely have a faulty speed control board WH12X10154, but you'll want to eliminate the timer WH12X10152 as a possible issue as well. You'll need to check the circuits and wiring at the speed control board and wiring, first.
I put a load of clothes in the washer, power is on, water fills and empties, but basket not turning and wash does not cycle. I had to manually move from one cycle to the next, but it stays in that position.
Answer Hello C.B.,
The tech sheet tells how to check for the issue when the tub isn't turning. The tech sheet should be found inside the unit. We can send you a copy if you want to send us a valid e-mail address that can receive attachments. This is basically what it says:
1.Advance the timer knob to the drain increment. If the drain pump or valve does not operate, check safety circuit. If the drain pump or valve runs go to step 2.
2. Turn the water off to the washer. Remove electrical power from the washer and remove the back panel. Remove the motor drive belt. Reconnect electrical power and set the timer to the start of the regular wash cycle and start the timer. If the motor runs check for a poor connection in the timer line switch, coin box circuit or door lock switch. If motor does not run go to step 3.
3.Remove the four pin plug from the speed control unit. Measure the voltage drop between pins 2 and 4. If the meter reads 0 check the motor thermal cut out. If the meter reads 120VAC go to step 4.
4.Remove the nine pin plug to the speed control unit. Measure the voltage drop between pin 6 of the nine pin plug and pin 4 of the four pin plug. If the meter reads 0 check timer contact 9 to 9A. If the meter reads 120VAC go to step 5.
5. Measure the voltage drop between pin 3 of the nine pin plug and pin 4 of the four pin plug. (Leave meter connected for more than 4 seconds) If the meter reads 0 check timer contact 24 to 24B. If the meter reads 120VAC go to step 6.
6. Remove electrical power from the washer. With an ohmmeter check the resistance between pins 1 & 3 of the four pin plug. If the meter reads about 6 ohms replace the speed control board. If the meter reads infinity remove the plug from the main motor, and with an ohmmeter check the motor windings.
•During 1st fill of WASH setting, tub may rotate up to three times in one direction before reversing direction.
•Extremely low water pressure may cause tub rotation to stop until WLC satisfied.