My washer will wash but when it goes in the spin cycle it will try to pump water out for about 30 sec then it will shut down. What do I look for? What could be wrong?
Answer Hello Adam. Based on the information you provided, it sounds like either the pump or hoses is clogged and needs to be cleaned out, or the drain pump WH23X10030 is bad and will need to be replaced.
Washer will fill and drain ok, washer will not activate main motor, lid switch ok, capacitor ok.
Answer Hi Dana. Un hook the belt part # WH1X2026 and see if the motor now will turn and try to agitate. I would use a volt/ohm meter part # TJMA-DM1 to assist. you in your diagnosis. Make sure it is getting the 120 vac to the motor from the timer/control board part # WH12X10220, If not then replace it. If the motor receives the 120 vac on the purple wire and the dark. blue wire then replace the motor part # WH20X10019. The belt is part # WH20X10019. You need to use the supplied wiring diagram in the control panel area or in the cabinet in a packet. Thank You.