Is this a part I can install myself? May I look at the installation instructions before i purchase this part?
Thank you.
Maria L for Model Number ZBD7100
Answer Maria, Here are the basics : " Remove the dishwasher outer Door Panel. Remove the six retaining screws which fix the Detergent and Rinse Aid Dispenser to the stainless steel door liner through upper and lower fixing brackets. The Thermistor Retaining Clip is attached to the right hand corner of the fixing bracket. Remove the Detergent and Rinse Aid Dispenser from the stainless steel door liner. Upon reinstallation of a Detergent and Rinse Aid Dispenser to the stainless steel door liner ensure the sealing face area is clean and free from damage. To ensure an effective seal between the Dispenser seal and the stainless steel door liner face, alternatively tension the two centre screws through the upper and lower brackets and then the upper and lower corner screws. NOTE: The right hand upper corner screw also clamps the thermistor retaining clip to the bracket face. Door Panel Removal : Open the door to the horizontal position. Remove 3 Phillips head long (21/2”) screws fixing the timber or stainless steel decorative panel to the door panel. Close the door. Lift the decorative panel upwards to disengage the toggles holding it to the door panel. Pull the decorative panel forward and lift clear from the dishwasher.Open the door to the horizontal position. Remove the remaining 13 Phillips head screws from the sides and top from the stainless door liner." It sounds worse than it actually is, you should do fine. Thanks and Good Luck