Drain Solenoid

Ray for Model Number gsd3400g00ww

Answer Hello Ray, The drain solenoid clicks when it is operating properly in the sense that when the solenoid activates you will hear an audible click sound pulling the arm down. 

Emory for Model Number GSD4920X73BB

Answer Hello Emory, You will want to check your drain hose and check to make sure that your disposal or drian pipe in sink is not clogged up. A slow drain is what causes the c1 and c2 error codes. If this checks ok then you would need to replace the control board. 

David for Model Number GSD2230L01

Answer Hello David, You may want to check the drain pump gate valve. If the gate valve did not return to the closed position then the pump needs to be replaced. You may also have a drain sensor switch that is shorted or closed. Do a continuity check on the switch to make sure it is open. If it is closed then you will need to replace switch. Also check your drain solenoid to make sure that it is not stuck down. If it is then it needs to be replaced. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html 

Eme

Answer Hello Eme! The pump and motor assembly WD26X10013 is available for purchase, the solenoid is not available separate. Thanks! 

Mario for Model Number Gsd4420x66bb

Answer Mario, Are you sure the water and the water shut off(usually under the kitchen sink) are open and the water is supplied to the fill valve. Check inside the tub,in the front left corner, and make sure the float assembly is not stuck in the up position. You'll need to remove the lower access panel and kickplate, and check the wiring to the water inlet valve and flaot switch assembly. A multimeter will come in handy to check the swich circuits and voltage to the fill valve solenoid.Here's some help on meter usage if you need it. [http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html] Thanks and Good Luck 

Pat Mnich for Model Number GSD2800G03

Answer Hi Pat. Unhook the drain hose end at the sink. Look inside to see if it or the sink is clogged. Make sure the pump is not clogged. Use dishwasher magic monthly to insure proper performance. Part # TJ104. If the drain solenoid rod is out of place then you will need to replace the solenoid with the updated kit part # WD21X802. If the unit continuous runs it needs the control assy. needs replaced. Part # is WD21X694. Thank You.