How do I get into the box? I took off back screws but no help. I need to replace the belt.
Answer Hello Don,
There are two screws that go straight up if you open the door and look up. They are long screws that go from inside the door into the main top. Once these are removed, the front of the main top can be lifted slightly to remove from the clips and the rear "clips" onto plastic clips on the bottom of the front of the control panel. These clips will slide out if you slide it to one side. There are then two screws holding the main front on. If you look straight down into the open top, the screws are located one on the left and one on the right. The thread in from rear to front about 3 inches from the top and thread in towards the front. When they are removed, the front can be lifted off of the front of the unit.
This should get you in to replace the belt. Let us know if we can assist you further.
dryer shuts off mid cycle with standard load. Works fine with a half load. When it shuts of it will start right back up. Runs for about eight to ten minutes and stops but always starts right back up. GE profile dpsr610gg9wt
Answer Hi Kramer. If you have to wait a period of a few minutes to start back up then the motor is needing changed part # WE17X22217. Now that you said it does well with a half load then I would suspect a stretched belt part # WE12M29 and a belt cut off switch issue part # WD21X10261. Use a volt/ohm meter part # TJMA-DM1 to assist you in your diagnostics. You can use a repair manual part # WX10X116 to help as well. Thank You.