No matter what setting I put the dryer on it will only run for 6 min and then shut down. After that I can immediately hit start and it will run for a nother 6 min and shut down, but hit start and it starts again...
Answer Hi. Use a volt/ohm meter part # TJMA-DM1 to assist you in your diagnostics. It will be advantageous to find the supplied tech sheet inside the cabinet to aid you in the diagnosis. It allows you to put the unit in a diagnostic mode which brings up fault codes and tells you which circuit needs assistance. E0 display if the thermistor has no error. E1 if an error exists. Then verify the thermistor part # WE4M275 reads 100K ohms @ 77° room temperature. Remove the CN4 connector at the rt. side of the transformer on the control board. Place the ohm meter on pins 5 & 6. Thank You.
The panel lights up and it works, but when I press to start nothing happens...the cotten cylce it flashes back and forth 1HR/38minutes...is there a way to reset it..I did unplug it...help...thanks!
Answer Hi Julesbegin. The first thing to do is to access the rear of the control panel. Remove power. Remove control back and get the factory tech sheet supplied with the unit. In this it will tell you what the cotton cycle code is. It is suggested here to change the main control board part # WE4M296. Thank You.