Burned out bulb
June R. • Dickinson, ND • December 26, 2014
My Repair & Advice
Replaced the bulb with a standard appliance bulb, recommended wattage, but the "gasket" behind the ring holding the glass cover over the bulb looked like a mat of fiberglass. It was almost impossible to get back into place without tufts of it sticking out of the metal ring. Went looking to see if there was a replacement gasket and found these recommended for my model oven.
Much neater than fiberglass pieces hanging in the oven cavity over food!
Main problem is the design and placement of the bulb compartment. Upper right corner..right next to the oven temperature sensor and two of the three screws holding the metal ring are so close to the sensor it is impossible to work there without bumping the sensor. Sensor should be on the other side, away from the bulb area.
Most Helpful Stories
People found this story helpful
Repair Time Estimate
Less than 15 minutes