I have model number 363.78567896 and the freezer seal AP2067912. You answered my question about the seal. Is there a manual or pdf I can use to help me take the door off and the screws? Any other suggestion? Thanks.
D for Model Number Kenmore Refrig 363.78567896 with Freezer Seal AP2067912
Answer Hi D. Before starting the change effort, fill the tub with warm/hot water and unfold the gasket as you place it in the tub. Or if it is a sunny day place it outside on a blanket to get it warmed up. Then remove the upper door hinge cover. Use a felt marker to mark the hinge alignment against the cabinet so it will be placed back correctly. Remove the food and inner door bins. Then remove the hinge. If there is a shim in between the hinge and the cabinet keep it with the hinge and screws. Unfold the gasket inside area to see if you will need a 1/4# nut driver or a Phillips screwdriver to remove all inner gasket screws. Then place the new gasket together with the inner door panel. Start the lt. and rt. center screws partially in to get started. Then make sure the gasket is uniform as you replace it all around. If there is any wavy side gaps you can use a hair dryer and a putty knife to relax the magnet going up and down as you heat the area. Be careful not to overheat the gasket. remember that when the door is evenly closed what is more important is the door seal -to - the cabinet area. Hand tighten all screws. Also you can use some white lithium grease on the hinge pins to keep them working well. Thank You.
I need the white freezer seal for my Kenmore Refrigerator. Is it item #AP2067912 which is also the GE Manufacturer #WR24X438?
Is there a video to see how to do this? Is it easy?
D for Model Number 363.78567896
Answer Hello D! Yes, the replacment freezer gasket is part number WR24X438. For the refrigerator door gasket use part number WR24X437. Unfortunately, we do not have a video available to show the removal and installation process. The door will need to be removed in order to install the seal and remove the screws from the existing seal. Pull the old gasket off. The new gasket will press into the door liner. With the installation, you will have to screw in the corners first and do every other screw on each side to tighthen. It may be best to soak the new gasket in warm water to help take its shape/form You may need to use a hair dryer to form the seal, be careful not to melt it. I hope this information helps you, thanks!
Would you ship international by air Part # AP2067911 and AP2067912 to Grenada?
Bert
Answer Hello Bert! Unfortunately, we are unable to ship outside of the U.S at this time and will need a U.S physical address to ship parts to. Sorry about that!