The igniter on two separate burners click when no one is using the cooktop. I think I should replace the igniter switch with harness. Is there any need to think it may be the spark module? Should I replace both?
Paul for Model Number jgp940bek2bb
Answer Paul,
The most likely cause of failure is going to be either bad ignition switches or bad wiring from the switches to the spark module. If all the burners were clicking then the spark module may be the cause but with it just being 2 then the switches would be more likely. You can test the switches by check for continuity on them in the off position. If they read continuity in the off position then they are bad and need to be replaced.
I'm purchasing this part and want to make sure its the correct part for my problem.
Peter
Answer Hello Peter. We will need your model number and need to know what is wrong with the unit. Thanks.