How to replace heating element or restring kit and how to get to it from back, top, front or where?
To install the restring kit you will need to use a putty knife between the main top and push the spring clips that hold it in place. Lift up on the main top and remove. Once the main top is removed you will need to remove the front panel and release the dryer belt. You will then want to go to the back of the unit and remove the rear cover. Remove the screws holding the bearing retainer in place. Once removed you should be able to lift the drum out and access the heater.
My dryer runs and turns around but no heat so am I safe to assume dryer heating element? What is the replacement for this?
Answer Hello Diana. Check and make sure you have 240 volts coming to the dryer. Check and make sure the unit is not set to Air Fluff. Also check the heater and thermostats and see if they are good. You can test these with a multi-meter TJMA-DM1. They should read closed for continuity. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html