Is it very difficult to remove this hinge and replace on this oven model? This is the second time this has happened where the doors do not close completely and seal off the oven.
I do not see instructions on how to remove the hinge. It was simple to pull the oven door off but getting to the hinge is not as obvious. Is this a do it yourself project. I am very handy!
To remove the hinges to replace you would need to pull the unit out of its installation approximately 6 inches. This will allow access to the hinge mounting bracket. The hinge and mounting bracket are a complete assembly. You will mark the position of the hinge bracket on the side of the oven case and remove the mounting bracket screws to remove the hinges. Install new hinges and slide unit back into position.
In the picture it shows it as a hinge and cover. The replacement part is only the hinge. The hinge cover is all bent up and cannot be used. Do I install without cover?
Answer Hello Jane,
I looked up the part you are asking about and it is listed as a door hinge assembly. The picture shows the hinge assembly and as best as I can recall, there is no hinge cover so it will install without a cover.