The "flap" for the ice in door feature is not working. What is the more technical name for the part I am looking for? Thank you.
With the dispenser door not opening the most likely cause for the issue will be that the solenoid for the dispenser door is bad. The part number for the solenoid is WR62X10055.
I had to replace my housing shield dispenser. When I removed the old one a spring came off I don't know where it goes .There was no instruction.
When looking at the spring, one end has a hook on it which will go on to the dispenser lever first. Once on it will hook on the dispenser and the flat piece will lay on the housing.
Is part ap4564709 hard to replace? Does the trim only pull out. With no picture it is hard to tell if it is the same one in my door.
Please send more replacement instructions if available.
Answer Hello Roger,
To replace the Housing shield dispenser kit you would grasp the lower part of the interface and pull out from the bottom. Once out there are 4 screws holding the housing in place. Once out you will transfer any parts that need to be transferred and reinstall.