Does this part come with installation instructions? Thanks.
Terry W. for Model Number GE TFX27FJC
Answer Hello Terry! No, the icemaker door assembly WR17X1586 does not come with instructions. Please see the following link to our repair forum to post a question for installation assistance. Hope it helps, thanks!
http://forum.appliancepartspros.com/newthread.php?do=newthread&f=9
The ice maker door does not close shut; do I need to buy just this part AP2064445, or have to add some kind of spring to keep it tight. I asked days before but no answer yet. Thanks for your pront respond.
Jose C. for Model Number tfhw27rrawh
Answer Jose', The dispenser chute door could be the issue, but I think you'll most likely find a different problem if you dismantle the dispenser " The door dispenser control panel allows the consumer to select water, crushed ice, or ice cubes. It is an interface to the main control board. 1. Use a screwdriver to unlock the tabs at the bottom of the control panel. Slide the bottom out and down. 2. Disconnect the wiring harness connectors. Note: Inner door panel must be removed to remove recess trim. Door Dispenser Target Switch
When depressed, the door dispenser target switch allows water, ice cubes, or crushed ice to be dispensed. 1. Remove door dispenser control panel 2. Remove 4 Phillips screws in the door dispenser housing. 3. Slide out the housing and disconnect the target switch and dispenser light connectors. 4. Spread out the locking tabs and remove the switch. 5. Push the chute duct door locking tabs back
and raise the assembly above the locking tabs. 6. Push the lower armature locking tabs (under the assembly) back and lift up the entire
assembly." Once you get the assembly out of the dispenser body, you'll be able to check the other components 9delay motor linkage and switches and levers. Good Luck.