I have replaced the ice maker motor but my ice maker will still not dispense ice. What else can I try?
You will want to check the wiring at either the upper or lower door for loose or broken wires. Also pull the dispenser housing with lever out to ensure that there are no broken wires and make sure that the dispenser lever is making good contact with switch. If all this checks ok then you issue would be in the main control board or the interface board in which you will have to voltage checks on them.
how to remove dispenser cover (part#93) in order to replace water dispenser switch
Answer Mike, Here's some help :"The dispenser assembly consists of the interface, display board, dispenser shield, and duct door functioning parts. The dispenser interface can be removed to access the display board and the dispenser shield mounting screws. The interface is held in place by 4 tabs that hold it to the dispenser recess. To remove the interface, it is necessary to grasp the bottom lip of the interface on either side and gently pull it towards you. There are 3 wire harnesses connected to the display board. Note: The interface and display board are replaced as a complete assembly. When assembling, insert top tabs into the top of dispenser recess fi rst, then snap the bottom into place.The dispenser shield can be removed to access the cradle switch, duct door, duct door solenoid, and dispenser LED lights. The dispenser shield is attached to the dispenser recess with 4 Phillipshead screws".