We ordered & received the oven door gasket strip from GE.
Can you give us instructions to install it?
We were sent gasket #AO195032001ME and appears to be a little short.
Do you agree this is the correct gasket for our model # oven door?
Thanks so much for your help.
Kate for Model Number JKP15WOAIWW
Answer Hello Kate. Here are the instructions from the manufacture. Hope this helps.
Oven Door Gasket
The gasket forms a seal around the front edge of
the oven liner and the inner door panel except for
approximately a 6-in. opening at the center bottom.
The gasket is attached to the inner door panel by a
chain of spring clips.
To remove door gasket:
1. Open the door completely.
2. Pull the end of the gasket out of the slots at the
bottom of the door.
3. Finish removing the gasket by placing a finger
under the gasket beside the clip and pulling
straight up.
To install gasket:
1. Locate the 2 clips on the gasket just right and
left of center.
Note: The gasket will go on easier if folded 90
degrees at the clip being inserted.
2. Place a finger on top of the spring clip and press
into the 2 center top holes in the inner door
panel.