Pump Drain Asm

Phil for Model Number PDW8680N20SS

Answer Hello Phil, If there are no clogs, the drain pump WD26X10039 will most likely have to be replaced because the impeller has to have damage incurred. 

Allen for Model Number GDWF160RSS

Answer Hello Allen, The drain pump WD26X10039 can be bad but I would dis-assemble the unit from inside the tub first to check all of the screens (filters). If the filters stop up, the unit will just recirculate the same old dirty water over and over. While you have the filters out, you can check in the bottom of the sump for any foreign debris. If no problems are found, I would remove the hose off of the inlet side of the drain pump to check for any foreign debris. You should also make sure the drain pump is running when the unit should be draining. I would hate to tell you to replace a component that didn't work because it wasn't receiving voltage. If it does run, replace the pump. If it doesn't, check for 120Vac across the wires to the drain pump. If there is no voltage there, the control module WD21X10385 is in question. 

Roy for Model Number PDW9280L00SS

Answer Hello Roy. Yes, based on the information you provided, it sounds like the module WD21X10229 is bad and will need to be replaced. 

Aj for Model Number PWD8280j10ss

Answer AJ, First thing, check and make sure the drain hose, and connectors are not clogged or kinked. Disconnect the drain hose from the disposal and drain the dishwasher into a large bucket. Remove the sump cover and filter, and reach down and carefully check and clean any debris from them as well, then replace the drain pump, if the problem persists. Thanks and Good Luck 

Lynn for Model Number GE PDW 9980L00SS

Answer Hello Lynn. Red goes to the "L" and white goes to the "N" terminal. Hope this helps.