GE WR2X7054 Push-on Nut - AppliancePartsPros.com

Total
$0.00

Part Number:	AP2059046
MFG Part Number:	WR2X7054
Made by:	GE

Our Price
$1.27
Regularly	You Save
~~$3.02~~	$1.75

Most Interesting

I've taken the inside washer parts out and cleaned everything up and it doesen't rinse the dishes properly there is still a white soap residue left on everything. What can I do to get it working properly again?

Frustrated for Model Number gsd4800jo1ww

Answer Hello Frustrated, You will want to check the spray arms for being clogged or dirty. You may also want to run a clean cycle using vinegar or affresh W10282479 to ensure that any component that would have water flowing through it is clean. Make sure that you are not using a detergent with a rinse aid in it in conjunction with a separate rinse aid.

Was this helpful?

I recently replaced the seal and push on nut WR2X7054. Due to the time laps between removing the parts and having to order replacements, I cannot recall which way the push on nut goes onto the shaft. (Concave side against the seal or away from the seal?). Thanks, Bob

Bob for Model Number HDA2120Z04BB

Answer Hello Bob. The concaved side should be facing upward. If trying to install wrong, the nut will not press onto the shaft.

Was this helpful?

Regarding my question about how far to push the nut onto the shaft, you said to push it until it locks the "cover into place on the unit". What cover are you talking about? The shaft is sticking out of the plastic pump housing, so I wasn't aware that I'm locking anything into place. Unless you meant the seal? I'm worried if I push the nut up too far, that the shaft won't freely be able to turn, which is why I'm wondering if that groove in the shaft by the pump housing is where I should stop. Thanks.

Bob

Answer Hello Bob, The groove is there to show how far to push the nut on.

Was this helpful?

Latest Questions

How far does this nut need to be pushed onto the shaft? Until the teeth fit into the groove at the top of the shaft near the pump housing?

Bob

Answer Hello Bob. You press the nut WR2X7054 onto the shaft until it locks the cover into place on the unit.

Was this helpful?

I am having trouble prying off the WD2X429 push on nut to replace the seal. Saw the note about working it off which I tried, but I am going to try to work up the "teeth" a bit with a dental pick and again pry with a small screwdriver. I have used plumbers grease on Moen faucet cartridges. Makes them work nice and smooth again. What about lubricating the new WD8X181 seal with it. This dishwasher is only used a couple months out of the year. Thanks, Rick

Ricknsue for Model Number GE GSD4010

Answer Hello RicknSue. No, just dip the seal WD8X181 in water and install it on the unit. The grease can make it work improperly on the unit. Hope this helps.

Was this helpful?

I have replaced the seal the way that the instructions said and the push on nut both went on fine. Put it all back together and it still leaks from the seal. What do I need to do?

Nick for Model Number AP2059046 and AP2038837

Answer Hello Nick. If you replace the seal and the nut and the unit still leaks, you may need to replace the pump assembly WD19X10013. Hope this helps.

Was this helpful?

Push-on Nut

Questions & Answers

Appliance Compatibility Tool

Repair Help

Questions & Answers

Most Interesting

Latest Questions

Cross Reference and Model Information