If we buy Item Number AP3794590 (electronic circuit board) from you, will we ourselves be able to install it, or are we going to need a GE technician?
Answer Hello Maria,
Discontinue the power supply to the unit before you start. Now remove the control panel and the board is under it. Once you get this far, the most important thing I can tell you is to remove one wire and install it on the new controller. Remove the next wire and install it on the new controller. Continue with this procedure until all wires have been transferred to the new part. Re-assemble in reverse order. DPGT750GC1PL
My screen shows the message model connection problem. In order to repair it do I need to order a new main power board?
Answer Hi George. I would use the digital capacitor Tester / Volt/ohm meter part # TJMA-DM1 to assist you in repair. Screen will display "Serial communication link between the washer and dryer is down. Please check for proper connection, the dryer is plugged in,or board input /output signals". The washer sends a signal back to the dryer acknowledging receipt of information. An error is set if the dryer has not received a proper response from the washer after 3- attempts. 1.) Check options to insure communications feature is selected or 2.) Wiring connections or 3.) Serial cable or 4.) Internal washer or dryer cable or 5.) Main Control board part # WE04X10107. Thank You.
Display is dead no sound. Only the inside drum light is on. I checked the fuse on the control panel and is ok.
Answer Hi Adrian. The main control board is part # WE04X10107. This is the brain to the unit. It is mounted behind the control panel. Remove the back cover and remove the top cover to the board. Inspect to see if there is the fuse open or the board circuit burnt. Thank You.