How do you reset a GE Profile Stainless Steel Bottom Freezer Refrigerator?
The only way to reset the GE Profile refrigerator is by unplugging it for a couple of minutes to let the control board reset.
My refrigerator is warm and not keeping food cold. Freezer seems to be working fine. Evaporating fan works ok. Compressor is warm to the touch. Condenser fan works. Could it be the run capacitor? We are at a loss.
Answer Hello Sparky. It sounds like you may have a defrost problem with the unit. Check and see if there is any frost build up on the evaporator coils in the freezer. If so, you will need to test the defrost heater and the defrost thermostat. They should read closed for continuity when cold. You can test this with a multi-meter TJMA-DMT3. I will include a link at the end to assist you how to use the multi-meter if needed. If both parts are good, Check the evaporator thermistor. If it is good, you will need to replace the control board. Once the problem is repaired, you will need to thaw out the ice on the coils before the unit will operate properly. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html
Refrigerator/freezer was not staying cold, really too warm. I replaced the condenser motor, but now the fan does not run???????????? Now what??
You will want to make sure that the condenser fan motor is getting power to it. If it is not then the control board is the most likely cause for the issue.