When I put my dishwasher in Rinse & Hold mode, it can drain all the water when it's done. So the water pump and drain solenoid should all be working. But when it is in full washing cycle mode, it goes through all stages just fine. But at the end, it leave a full tank of clean water in the washer. I have replaced Sequence Switch (AP2039701) and the control board assembly (AP3191005). But the same problem still exists. Any other ideas? Thanks much.
Siming for Model Number GE ZBD3500ZZ1WW
Answer Hi Siming. Did you totally remove the drain hose and verify it is clear ? Is the check valve flap inside the pump output in good shape so the pump does not cavitate ? It is part # WD01X10175. It also helps to insure that there is no back up of sink water. You need to verify that there is a loop under the sink clamped tight as high as possible then taught to the sink drain or disposal. This will create a p-trap effect as no sink water or drain waste smell back up in the unit. Make sure the sink or disp. connection is clear to drain into it. Follow the installation instructions supplied with the use and care guide. The pump is part # WD19X10015. Look inside the pump and check the impeller to see if it is damaged or loose spinning on the shaft. Thank You.