I replaced the Smart BoardOEM now it's asking reset, how do I do that?
Answer Hello Greg. A reset is performed by unplugging the unit for about 5 minutes and then plugging it back in.
Controls work, heating elements don't heat up. Replaced both elements.
Answer Hello Don. You need to test for power from the control to the element. If it is not there, the control is bad. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html
My microwave works great when the table turns! When you start the oven and the table does not turn it does not heat! Sometimes it works and other times it does not, if the table turn you get a not meal! Is this the part that controls the magneto and the turntable??? Thanks Joe.
Answer Joe, Are you sure there is no heat at all in the food, not even in the center? If that's the case, you'd want to start by checking the primary door switch WB24X830. This switch allows power to the turntable motor and the high voltage transformer. If the switch is faulty, you'd have an intermittent turntable and no voltage to produce microwaves. If the turntable motor is faulty WB26X10025 the food would be warm, usually in the center, or one area, The turntable turns the food for a more even distribution of heat. We wouldn't expect the control board to be at fault WB27T10091 at this point, but there is a slight possibility of a weak relay on the board.