GE WR62X58 Solenoid & Arm Assembly - AppliancePartsPros.com

Total
$0.00

Part Number:	AP2071947
MFG Part Number:	WR62X58
Made by:	GE

Our Price
$57.52
Regularly	You Save
~~$79.57~~	$22.05

Most Interesting

My ice maker will not switchover from crushed ice to whole ice. I watched it from the inside and it looks like it doesn't have enough power to lift the arm up to make the switch over.

Trevor

Answer Hello Trevor. You will need to remove the solenoid and see if it is rusted, causing the shaft not to work properly. If so, you will need to replace the solenoid. Hope this helps.

1 person found this answer helpful.

Was this helpful?

My ice maker will make ice, but the thing inside will not turn to make ice come out though the door. What is wrong? It will just click.

Mark S for Model Number gss22wgmdww

Answer Hello Mark. You will need to test and see if your getting power to the auger motor WR60X10258. To test this, you will need to hold the door switch closed and press the dispenser button to activate the motor. If there is no power there, you may have a bad main board assembly WR55X10942. Hope this helps.

1 person found this answer helpful.

Was this helpful?

Water and icemaker quit. There is water from filter down to solenoid. Any way to check solenoid or should I just replace it?

Mike for Model Number HSS25GFPAww

Answer Hello Mike. You can test the water valve WR57X10032 and see if your getting power to it. If there is power there, then you will need to replace the valve. If there is no power there, then you may have a bad main board. Hope this helps.

1 person found this answer helpful.

Was this helpful?

Latest Questions

I am trying to replace the solenoid & arm assembly AP2071947. How do you remove the J-nut ? that holds the auger drive part (365) on diagram. I know that is a reverse thread and I am trying with a pair of vise grips to loosen it (turning to the right) and I loosened it just a little bit but then it just seems stuck. I do not want to round off the bolt so I stopped and know I'm stumped. Is there a trick to getting that off? Please help.

George for Model Number GSL25IFRF BS

Answer George, It is not necessary to remove the J-nut on the unit in order to change out the cube/crush solenoid. You would just need to pull the complete auger motor housing out. With this out you can access the solenoid. To get the j-nut off it may be necessary to tap on it with a mallet.

Was this helpful?

The ice dispenser does does not dispense cubes, but it will dispense crushed ice. The auger is working. The white part at the back of the ice dispenser unit (in the little window) will not raise up...am assuming this is the solenoid arm. Suggestions?

John for Model Number TFX22ZPBGBB

Answer Hello John, Yes this is the solenoid arm in the little window and it sounds like the solenoid WR62X58 is defective and would need to be replaced.

Was this helpful?

My water quit, and no water going to the ice maker.

Richard for Model Number HSM25GFRE SA

Answer Hello Richard, You can determine if it is the icemaker or the water valve by checking for voltage at the water valve when the icemaker should call for water. You should have 120 vac and if you do then you need a new water valve. If no voltage then you would need a new icemaker.

Was this helpful?

Solenoid & Arm Assembly

Questions & Answers

Description

Appliance Compatibility Tool

Repair Help

Questions & Answers

Most Interesting

Latest Questions

Cross Reference and Model Information