Solenoid Assembly

Ed K.

Answer Hello! When you put your model number in our website it should show you a breakdown of components on your dishwasher. There should also be a wiring diagram on the unit itself. There are no specific directions on installing a particular part other than a generic repair manual for a dishwasher. Thanks! 

1 person found this answer helpful.

Eugene for Model Number gsd3425f00bb

Answer Hello Eugene. WD21X10060 is the correct solenoid assembly and comes with all that is needed. 

Ray for Model Number HDA3400G02BB

Answer Ray, If you mean the timer WD21X10155 as the "motherboard", then yes, the issue is most likely in the timer circuit to the drain solenoid.The timer contacts are most likely arced together and send voltage to the drain solenoid all the cycle time. 

Keith M. for Model Number HDA3220Z04BB

Answer Hello Keith, The first thing to check is the door strike and switch WD21X10261. If this checks out, the timer WD21X10013 should be checked for voltage to and out of it. If voltage gets to a component, but isn't passed to the next component, the component has failed. 

Brian F. for Model Number GSD2220Z05BB

Answer Brian, The Drain valve arm WD35X192(white plastic piece) is keyed on the drain flapper shaft and held on/in place by the "C" clip. You will need to use a sharp pointed awl or small flat blade screwdriver to remove the clip , then slide the arm lever off the shaft. 

Kevin for Model Number GSD3200J00WW

Answer Hello Kevin. Yes, based on the information you provided, it sounds like the timer WD21X10201 is bad and will need to be replaced on the unit.